Earthquake Sound PA-600 specs
General info
Home
Amplifier usage:
Power amplifier
Type:
Power amplifier
2
Amplified channels:
120W per channel into 8 ohms measured at frequencies from 20Hz to 20kHz
Power output:
200W per channel into 4 ohms measured at frequencies from 20Hz to 20kHz
300W per channel into 2 ohms to 1kHz
Yes
Bridge mode:
330W into 8 ohms
Power :
600W into 4 ohms
20 - 20kHz at +-0.5dB
Frequency response:
89dB
Signal to noise ratio:
40V per microsecond
Slew rate:
over 300 to1kHz at 8ohms
Damping factor:
Connectivity
Unbalanced (RCA): 2, Balanced (XLR): 2
Inputs:
Binding post terminals
Speaker connector type:
Banana-plug compatible
If you are interested in using our specs commercially, check out our Amplifiers specs database licensing page.
Filed in: Earthquake Sound Amplifiers
Description: Earthquake Sound's PA600 can be used in Stereo Mode as two separate power amplifiers, each capable of driving loads down to 2-Ohms. Each channel operates independently and has its own input connectors, sensitivity level controls, signal indicator LEDs, limiter circuitry, fault protection circuitry, power amp, and speaker output.